7.2V-12V NiMh/Nicd battery pack charger with MCU intelligent control
Features
Charger for chargingNiMH /NiCdbattery packs-7.2V, 8.4V, 9.6V and 12V(6-10 cell pack) used in high-end airsoft guns, RC cars and airplanes
Fast charging with current switch to either 0.9A or 1.8A. Full charging takes 1 - 2 hours
Charging Current 0.9A for battery packs with capacity from 900mAh -1800mAh
Charging Current 1.8A for battery packs with capacity above 2000mAh. For 3000mAh pack, charging time is 1.5 hours
Smart automatic voltage detection
Pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack life
Red LED is on during charging
Automatic charging ends with negative delta V
4 hour safety timer: Charging will stop after 4 hours of operation
Worldwide usage with 120-240V AC
Safety protection fuse for over current, short circuit & reverse polarity protection
Operation Instruction
Connect battery pack to output connector and plug AC power source
Make sure battery polarity is connected correctly (Red wire is positive)
Charger will detect battery voltage automatically. Red LED is on during charging
When battery is fully charged, current will reduce to trickle charging at 50mA and green LED will be on
Battery will be charged at 0.9A or 1.8A constant current
Approximate charging time is about 1.5 hours for 3000mAh battery,1hour for 1800mAh battery
Charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun
NEVER charge battery packs with voltage less than 6V or voltage greater than 12V and the capacity smaller than 1100mAh
Batterypack must be made by high drain current cell
Product Specification
For 7.2V-12V NI-MH/NI-CD battery pack 6-10pcs
Input: AC100-240V
Output: 7.2-12V, 0.9 or 1.8A
Accessories Included
1 standard Tamiya connector with the smart charger
1 connector adapter from standard Tamiya to Mini Tamiya
1 set of alligator clip adapter with standard Tamiya connector on one end
WARNING!
The charger is designed for indoor use only and it is NOT for charging any LI-PO battery
Never leave the charger unattended during charging
The charger should be laid horizontally and work in a well ventilated condition
Avoid water and keep away from flammable and explosive goods
Do not cover the charger when charging. Ambient temperature shall not be more than 40oC(104 degrees Fahrenheit)
Don't touch the plug. Keep away from children
Do not leave the battery and charger on wood surface or carpet while charging
Turn off power supply before connecting or disconnecting the charger to battery packs
Never disassemble the charger
Contact seller for questions. Both manufacturer and seller are not responsible for any damage and consequent damage caused by misuse of this product
Dimension
Outline dimension:120L X 60W X 38(H) mm MAX;
Request A Quote
